Calculation specimen measurement specifications for equipment b

Measurement specification: Drawing CINI 8.5.01	Equipment in m²
Component	m²	factor	eq.m²
Shell
( 2500 × 5000 + 2000 × 3000 )	58,10	1,0	58,10
Dome head
( 2000 x 600 + ¼ x 2000² )	6,90	2,5	17,27
Conical reduction
× ½ ( 2500 + 2000 ) x 500	3,53	2,0	7,06
Conical end piece
× ½ ( 2500 + 373 ) × 1000	4,51	2,0	9,02
Vacuum rings
× 2700 × 300	2,54	2,0	5,02
Accounted for separately Cut out + cover plates 10" (at the top side) Cut out + cover plates 4" 2 units Cut out 10" (conical section) 10" - 500mm to be accounted for as piping			p.m. p.m. p.m. p.m.

To read the full article you have to buy a license for the online manual, with this license you have acces to the manual for one year.